self aligning ball bearings
This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.However, depending on the surrounding structure, such an angle may not be possible.
A self-aligning bearing is recommended when the alignment of the shaft and housing is difficult or when the shaft may bend during operation. Brda notes that similar to deep groove ball bearings, most self-aligning ball are for general use.

- 60 mm x 130 mm x 46 mm FAG 2312-TVH self aligning ball bearings
- Single Lip Contact
- Bearing

- 95 mm x 170 mm x 32 mm NACHI 1219K self aligning ball bearings
- SEALMASTER
- 0662288479857

- Toyana 2219 self aligning ball bearings
- B04264
- Bearing Plain Radial

- 25 mm x 42 mm x 20 mm ISB GE 25 BBL self aligning ball bearings
- 8865590654925
- B00152

- 70 mm x 150 mm x 51 mm NACHI 2314 self aligning ball bearings
- 0.363
- PT INTERNATIONAL

- 10 mm x 30 mm x 14 mm ISO 2200-2RS self aligning ball bearings
- 3.937 Inch | 100 Mil
- TIMKEN

- 75 mm x 160 mm x 55 mm NSK 2315 self aligning ball bearings
- Ball Bearing
- 0

- Toyana 2314 self aligning ball bearings
- Bearings
- M06110